M-jet-35 Rc Jet Boat 3D Printing with Metal Propellers KIT RTR

Rtr does not include battery boat weighs approximately: 2.64kg
The length of the nozzle is 495mm excluding the air pump, about 520mm including the air pump, 240mm wide and 190mm high
1. suitable for mjet35 airbrush pump, single hull does not include pump 499, plus hardware mjet35 pump printing parts +65
2. the hull + hardware air pump 700, exclusive improvement of 2 in and 2 water cooling (free metal water inlet grids), including assembly + waterproof.
3. the hull can be played with with a battery + rtr hobbywing neptune 120a esc (better than 150a from other brands) + surpass3660 motor 1400kv + bey-trc1 with screen remote control + metal gear waterproof servo
4. welding top spotlights +50 (welded lamp wiring + waterproof hull opening)
5. personalized special coating stickers, waterproof material, can be photographed together and shipped
The hull has been improved to form two sections, and its strength is much better than the three or four sections, and the design is designed with "steel bar" to connect and strengthen! the angle of the pressure wave board is adjustable, with
Effectively solve the problem of water bleaching.

Precautions for jet boats
1. it is recommended to use a pair of 2-3s4000-6000 mah for batteries. before playing, be careful to check that the water pipe is not foldable to avoid overheating and damage to the electrical equipment.
2. check whether the motor seat screws, servo arm screws, and coupling machine screws are tightened before entering the water.
3. if there is any abnormal sound when playing, it will drive back at low speed immediately. if the fruit screws are loose, the blades will be damaged by the spray pump. the power is weakened when driving, which means that the voltage is too low or overheating protection. the same low speed will drive back for inspection.
4. the two m3 screws on the air pump are filled with lubricating oil. you can fill it once after playing 3 or 5 times. it is easier to fill than the flexible shaft each time. The m4 screw in the lower left corner of the tail is a water drain screw. if there is water inside the boat, it cannot be poured cleanly. after playing with the boat, it is recommended to open the boat warehouse and put it upside down on the carton to dry.
5. the static water turning boat can spray air back at low speed, not large throttles. if the boat is turned over, the water will not be fully absorbed into the water. the continuous throttle will overheat.
6. summer is not allowed to be exposed to the sun in the car. in summer, the temperature in the car can reach 90°, normal outdoor 40° It has no impact on the weather when going out to play.