Drifting Beast 1/24 Rc Drift Car Frame Kit All Op
Newly designed frame db (drifting beast)
1. The whole car adopts a hollow design, without a chassis, and is supported horizontally.
2. Although a large area of metal materials is used, due to the large area of hollowing, the effect of lightweight metal is achieved.
3. The front shock position has been changed to the inside of the front of the car to avoid the interference caused by the maximum steering of the front wheels to the greatest extent.
4. A straight bridge structure is adopted at the back. When the car is transferred by the center of gravity, the contact angle between the rear wheels and the ground remains unchanged, and the same grip is always maintained. It can also be changed to the method of straight bridge and connecting rod. When the center of gravity is transferred, the contact surface between the rear wheels and the ground changes with the change of the center of gravity. The basic version includes three sets of rear wheel cups, two corresponding to the straight bridge mode, and one corresponding to the semi-independent mode. There is no need to buy them separately.
5. The body and rear gearbox are designed in one piece.
6. The main part of the body is made of mirror stainless steel, and a little polishing will give a mirror effect.
7. Four steering gear arms are standard, covering basically all mosquito car steering gears on the market.
8. Two motor seats are standard, supporting brushed 130 motors and non-sensory brushless, sensory brushless and other motors.
9. The frame does not need to install gaskets, and the tightness of the swing arm can be adjusted by the tightness of the screws.
10. The left and right positions of the motor can be fine-tuned, the motor is centered, bid farewell to the crooked motor effect, and cure obsessive-compulsive players.
11. The rear straight bridge wheel cup is adjustable, and the inner and outer eight can be adjusted at will. In the later stage, the telescopic dog bone will be launched, and the rear wheel pitch can be adjusted without changing the wheel hub.
The wheel hub electric car shell in the following display picture is not included in the product, and the product only includes the frame and the relevant accessories listed above.、
The front OP kit has been launched, 7 high-precision metal parts + 4 extended positive and negative tooth tie rods, the op parts have been assembled, just remove the original front parts and replace them directly. See the following figure for details.
