JDM128 1/14 RC Hydraulic Telescopic Arm Forklift RTR

JDM128 1/14 RC Hydraulic Telescopic Arm Forklift  RTR
Scale: 1:14

Dimensions: length 553, width 220, height 232, unit MM

Net weight: 9.12 KG, plus remote control 9.6KG

Packing size 860*370*340MM, packaging weight 13.6 KG

Lifting force: A. Telescopic arm retracts 4 kg

         B. 1.5kg after the telescopic arm is extended

         C. Bucket turning force 2kg

Standard accessories of the vehicle: bucket + fork + hydraulic grab, both front and rear axles are equipped with differential locks, both front and rear axles can be steered, four-way hydraulic valve, with hydraulic quick release, making tool replacement faster

two. Battery instructions:

1. Remote control: Fusi I6S uses 4 AA batteries (not included, you need to prepare them yourself)

2. Main car battery: 11.1V 3S lithium battery (not included, you need to prepare it yourself, the connector is XT60)

3. Battery size: within 100MM in length, 35MM in width and 35MM in height (battery, charger and power indicator need to be purchased separately)

three. Boot operation steps:

1. Confirm that the CH5/8 switch position of the remote control is upward and the CH6/7 switch is in the neutral position, return the joystick to the neutral position, and then turn on the phone after confirmation.

2. Turn on the remote control switch (press and hold both switches at the same time for 2S), and the interface display will open.

3. Connect the battery to the main vehicle power supply, wait for the signal sound (within about 5 seconds), and operate only after confirmation.

Notice:

1. If the power-on operation sequence is reversed, it will cause the ESC to enter the setting mode, causing the ESC to not work properly.

2. Remote control battery installation: Pay attention to the positive and negative poles of the battery during installation.

3. Before installing the main vehicle battery: measure the voltage first. The voltage cannot be lower than 11V.