Feng's SCX10 III 3rd Generation Transmission Shift Servo Protection Kit

Axial SCX10 III SCX10 third generation transmission interrupter/shift protection modification, industrial-grade MJF 3D printing technology (not comparable to DIY-grade printers), high material strength, excellent mechanical properties, can be installed directly, a small amount of stock.

This kit is for one car, including kits for two servos.

Attention! Attention! Attention!

This kit needs to use the output gear of the standard futaba servo with 25t output gear. The tr4 servo of Power HD is recommended (why choose it? Metal gear, high pressure, waterproof, digital mode, the reliability of other small servos is not satisfactory)

Orders are accepted on Saturdays and Sundays but not shipped....

Servo protection installation method:

1. Please read the original manual carefully before installation;

2. It is recommended to make a fake assembly before installation (gesture);

3. Turn on the remote control power, enter the channel end point (END POINT) and set the left and right end points of this servo channel to about 10%;

4. Turn on the ESC, power on the servo, ensure that the servo steering amount is at the midpoint relative to the activity of the shift control arm, insert this servo protection part into the servo, and screw the top screws (machine screws) on both ends. Note: Please do not use an electric screwdriver; do not use too much force, just use enough force when you encounter obvious resistance;

5. Install the shift rocker arm, spring and other parts in sequence according to the original manufacturer's instructions;

6. When installing the top cover, please do not screw the top cover screws to the bottom. It is recommended to leave a gap of about 1mm between the top cover and the shift rocker arm;

7. Adjust the servo stop point to the appropriate position.